Patterson Kelley

Ebay Item number: 7578289711purchased from gypsysWe originally offered out for $12500.009/9/10 - according to Dick Martin - this is 8 ft. 5 in. tall.There are no holes in the unit. - we believe it is repairablethose are the weak points on the vessel.appears solid - no holesa mending plate was placed over the inner section of left sideright side & center.6/22/05 - Jim Siegel has customer for this piece - asked if it is $12500 informed him that it is $9500one cover - completeone missing cover but securring rod is there.COMMENTS:John please regester the following as my customer Ray Wolf or any 1 from Rapid Plastic AKA Entec Houston Texas Thank You Very Much Jerry DillAt present time we will listen to anything over $ 9500. After repairs we may change the price.(11/26/02 - JA OFFERED OUT AT $8500 AS-IS) $10000.00 we can offer the welding repaired. - Dick thinks Mark can do it for around $600 +.3/8/04 - creativeflavors4aol.comDear MikeBefore I answer your questions I would like you to provide us with your contact information (Your last name company name and phone number. Mailing address would be nice as well).To answer your questions:3/6/04 - I am interested in the Inventory #: 1522 - 20 CU. FT. P-K TWIN SHELL BLENDER -S/S - 3. Does the blender work?* In production when we acquired it.How much would you say the repairs would cost? * not sure have not received quotes.Is $9500 neg.? * YES WE ARE ENCOURAGING AS-IS OFFERS ON THIS PIECE.* This blender is not recommended for food use. A comparable unitsuitable for food would be priced considerably higher.By the looks of your e-mail address I'm guessing you are in a food industry? Please let me know if this is the case. Since #1522 was last used for plastic pellets. And the fact that it requires welding repairs I would not recommend it for food service. Please advise specifically what you will be using the blender for. I look forward to your reply and corresponding with you further.4/22/04 - Email from cust #20097 - On piece# 1522 it appears that the motor is either unusual or perhaps there is a typo can you please clarify? 5/19/04 - Sorry for the delay in responding to you the motor information is correct presently it is wired for Canadian voltage.