Wm. Boulton Type 24 x 24

SOLDIngalls #1245 - Avail. conf. 10/28/09$3950.00 LESS 15%PAINESVILLE OH MANABU:JonThank you for your information.Don’t you think you will be able to have manufacturer name of #4683 somehow? – NO. IF THERE WAS A MANUFACTURER’S TAG IT FELL OFF.And what kind of set-up do we have to have for #4683 and #4682 before we use? - THAT IS UP TO YOU.Power line is enough or we need to have more stuff? WHATEVER ELECTRICAL THAT WOULD BE REQUIREDFOR A MOTOR OF THAT SIZE. NOT SURE WHAT ALL YOU WOULD REQUIRE.Do those machines come with ready to go condition?THEY ARE MECHANICALLY FUNCTIONAL (MOTOR WORKS MACHINES ROTATE). THEY ARE USED PIECES OF EQUIPMENT. THERE ARE NO WARRANTIES EXPRESSED OR IMPLIED. ALTHOUGH THEY LOOK OK WE ARE NOT GUARANTEEING THE CONDITION OF THE LINERS OR ANYTHING ELSE ON THESE MACHINE. THIS IS NOT NEW EQUIPMENT WITH WARRANTIES. IF THAT WERE THE CASE THE PRICES WOULD BE SIGINIFCANTLY HIGHER. THEY ARE PRE-OWNED USED MACHINES AND PRICED AS SUCH.Hi JonThank you for your quote.Could you give me more information regarding #4683 & #4682 please?(Manufacturer inside volume overall dimensions current requirement…etc)And are these prices for lease or sale?Thank you againManabu Tanaka 1/17/05 - cust #23841 - Please send me more information with price for your rubber lined ball mills #4682 (22x22) Boulton and #4485 (3'x4') Paul Abbe. What materials were milled using these ball mills? What is the conditions of rubber?1/18/05 - per vendor - They both came out of a chemical plant. It may have been barium carbonate. These have been cleaned but still show some residue or coloring on the lining. The lining on the boulton is good. The lining on the 3 x 4 could use work around the door area.Your customer should inspect these prior to purchasing.5/27/05 - cust #23841 - What materials were milled in this ball mill? (to vendor 6/8/05) 6/8/05 - per vendor - It came from a plant that did something with Titanium Dioxide and Barium Carbonate.I have no idea if this was used for either of these items.6/10/05 - The mill has a motor 3 hp 1750 rpm. It is not mounted on the mill and does not have a V-groove pulley.The mill has a 16 in. dia. V-groove pulley. That pulley and shaft turns a pinion gear that turns a big gear which controls the mill rpm.The 16 in. dia. pulley turns 6 times to every one revolution on the mill. (6:1 ratio).If you had a 4 in. pulley on the motor shaft the mill rpm would be 72 rpm. If you used an inverter to slow it down 72 would be your high rpm.Attached picture show the drive end. The pinion and bull gear are under the blue cover.6/10/05 - cust #24039 - Hi Seth I have a couple of questions regarding the ball mill Eugene is interested in 1st what parts are missing what is the motor voltage phase hp. What parts are missing ? please be more specific. What is the overall condition of the mill.