Hardinge

Ingalls #0713 - Avail. conf. 8/26/09price reduced 7/15/1035k net but willing to wheel & dealA.E.C. LESS 15% (OTHER DEALERS ONLY GETTING 10%)HARDINGE NOW OWNED BY METSO MINERALS OF YORK PAMr. QuirozThey were last used at a Zinc mining facility.Material was run through the rod mills to break it down beforegoing into the ball mills at the facility.Jon#713Category: MillsHardinge Rod Mill . one(1) used Hardinge Rod Mill. 6ft dia. x 12ft long with steel lining. 200 hp Elliot motor 440 volt. with Falk gearbox. Crane scale showed the weight to be 48000 lbs. Price: F.O.B.: Johnson City TN $35000.00Subject to prior sale or withdrawal.These specifications are correct to the best of our knowledge obtained from sources deemed reliable. Therefore you should make an inspection prior to the sale. Please contact us to set up an inspection or to discuss your equipment needs. A complete list of terms and conditions will be mailed upon request. 11/28/06 - 11:47 AM - NEIL at NELSON MACHY #2361 - 6 X 12 HARDINGE ROD MILLCONDITIONBETTER PICSrough dimensions & wt. - to be exportedCONDITION OF THE PINION & GEAR GEAR COUNT IF POSSIBLE (# OF TEETH ON PINION & BULL GEAR)SHOT INSIDE MILL - TO SEE CONDITION OF LINERA LITTLE BIT MORE DETAIL THROUGH PHOTOGRAPHS604-985-53315/30/03 - per Ingalls answers to Customer questions re: this piece: 1. How old is the rod mill? Estimated to be built 1950-1960 2. Are spare part available'? YES 3. Does rod mill have rubber lining? NO 4. End linings of steel or rubber? Steel 5. Percent worn out? Estimated to be 30% 6. Any rods available? NO 7. Any documentation available? Blueprints 8. Any maintenance report available? NO 9. Any information about gearbox motor and bearings? 200 hp motor w/ Falk Gearbox10.Previously milled products Believe Zinc6/12/03 - Additional cust questions: 1. How do the lifters look? 2. Any possibility for more digital photos both inside and outside both ends?3. Where is the rodmill produced? 4. Does the manufactory company still exist?6/18 - Per vendor: Lifters look to be in excellent condtion.I will be in Tenn. at the end of July. I will take more pictures then.The Rod mills were made by Marcy and Hardinge. Both companies have been bought out by Metzo out of York PA. This is the same place Hardinge has always been.Yes they still exist.8/28/03 - cust #18882 questions - Do you have a picture of the lining?We like to operate this mill as a ball mill with overflow system so the lining and the in- and outlet diameter are important for us. Where is the location of the mill?9/9/03 - inq to vendor9/25/03 - email to cust: I apologize for the delay in getting back to you. Attached are additional photos of the Ball Mills. We have two 6’ x 12’ rod mills. One is a Marcy and one is a Hardinge. Both companies are now owned by Metzo York PA.This is the same place Hardinge has always been. The Hardinge is one 12’ piece.Discharge is about 24 in. in diameter. Based on the blueprint we believe that it was made in 1957If you are still interested in this piece I can send you blueprints as well. This piece is presently located in Tennessee.