Chicago Boiler KD 45

INDURON COATINGS (ADDED 5/9/17)THEY WANT $8K FOR IT LOADED ON TRUCKLOCATION BIRMINGHAM AL 5/10/17 - QUOTED DICK INGALLS $17500 LESS 15%From: Jon Arnold [mailto:jon@arnoldeqp.com] Sent: Tuesday May 09 2017 4:35 PMTo: Jeff WhiteCc: Mike NelmsSubject: RE: SCHOLD 25 GALLON VERTICAL SAND MILL QUOTATIONJeffThanks for the info. I would only be interested in listing both of them.Both have been added into our inventory and can be seen at:www.arnoldeqp.com/product/8880www.arnoldeqp.com/product/8881 I have all the info on the vertical mill from when I sold it to you and am noting you're looking to get $4000.00 for it. I would like to get some current photos of it please. On the horizontal mill please confirm the following:Is it stored in a temperature controlled building?Enclosed building not temp. controlledCapacity - is it 45 liter? YesMotor horsepower phase hz voltages amps - CONFIRM 50 HP 3/60/460VYesIs the motor UL Listed?UnknownHow is the mechanical seal on it? Is it still in good condition?Unit was operational when pulled from service had been reconditioned by CB Mills approx 3yrs before w/little use since.Overall mechanical condition of the unit? Is it ready to plug in and run?Been out of service for about 4 yrs would recommend replacing main o-rings before start up just to be safe although they may be fine. We have a box with some spare o-rings and such that would go with it. I believe these o-rings would be in there as we normally kept spares.Anything mechanically wrong with it?The start/stop controls are not included on the unit we have since used these on other equipment .How is the lining on the chamber? Smooth or rippled?As stated above very little use since reconditioning so the chamber and discs should be fine.Does it have discs pins other type of rotors?DiscsAny spare discs pins etc…Small box w/spare o-rings and other small parts. No major spare partsIs it jacketed?YesDoes it come with a gear pump?NoYear built?UnknownWhat are the materials of construction on the contact surfaces? - chromed steel?Stainless steel? Plastic lined? Other?StainlessI've added it based on the information I have thus far and have noted you're looking to get $8000.00 for it.Location of both machines??? Birmingham AL????YesThanks.