CMX DPX-160L

CMX PROCESS TECHNOLOGIES (PRICED 5/16/14)$145000.00 LESS 10% VACUUM$130000.00 LESS 10% NON-VACUUMCONTACT DOUG COHEN FORMORE INFORMATIONPROPOSAL PREPARED FOR:Arnold EquipmentDATE:January 23 2014COVERING:One (1) CMX Double Planetary Mixers Model DPX-160. Unit has a minimumrecommended working capacity of 30 liters (8 gallons) a maximum recommended working capacity of 160 liters (42 gallons) and a full holding capacity of 178 liters (47 gallons). Unit includes the following features and specifications:CONFIGURATION & COVER LIFTING SYSTEM:Removable-Vessel design configured for use with multiple mixing vessels.Compressed Air / Oil hydraulic lifting system with two-hand operation raise / lowercontrols to raise and lower vacuum hood and agitators from the vessel (80 - 90 psigcompressed air required).Limit switches to prevent operation of agitator drives when the dust hood is lifted frommixing vessel or when the mixing vessel is removed from the mixing position.MATERIALS OF CONSTRUCTION & FINISHES:All product contact parts including agitators inside of vessel and inside of vacuumhood to be type 304 stainless steel polished to a surface finish roughness average (Ra)< 0.8 um (~80 grit).All non-stainless steel exterior surfaces are coated with a chemical-resistant two-partcoating.All elastomers (including mechanical seal O-rings) are Viton.Exterior of vessel and vacuum hood to be polished to a surface finish roughness average(Ra) < 0.8 um (~80 grit).OPERATIONAL PARAMETERS:Unit designed for operation under full vacuum up to 29.5 Hg (-1 BarG).AGITATION SYSTEM:Agitation system for mixing high viscosity formulations consists two (2) rectangularplanetary stirrer blades that rotate on their own axes while revolving around a commoncentral axis. Includes the following:Variable speed planetary stirrers driven by a 15 HP TEFC proof inverter-duty motorsuitable for 3 phase 60 Hz 230 volt input for an orbital speed range of 12 - 36 RPMand stirrer blades on their own axes between 13 - 39 RPM.Type 304 stainless steel cast gearbox housing with special gearing capped gasketed &sealed. Pre-drilled for addition of sidewall scraper arm. Exterior polished to a surfacefinish roughness average (Ra) < 0.8 um (~80 grit).Stainless steel sleeve bearing.Special mechanical seals on stirrer shafts.Type 304 stainless steel rectangular stirrers and stirrer shafts.Variable speed is accomplished through the use of an AC variable frequency inverterdrive located in the control enclosure described below.Underside of bonnet above vacuum hood is made of or sheathed in stainless steel.Stirrer blades polished to a surface finish roughness average (Ra) < 0.8 um (~80 grit).REMOVABLE VACUUM MIXING VESSEL:Stainless steel type 304 removable vacuum mixing vessel with flat bottom to include thefollowing:2 Flush Tank Ball Valve with 2 NPT threaded outlet connectionNo jacket.Two (2) fixed and two (2) swivel caster wheels.Interior of vessel polished to a surface finish roughness average (Ra) < 0.8 um (~80grit).Two (2) stainless steel steel lift trunnions attached to the exterior of the mixing vessel.One (1) stainless steel push / pull handle attached to the front exterior of the mixingvessel.VACUUM HOOD:Stainless steel type 304 vacuum hood to include the following:Two (2) 3 diameter combination sight and charge ports with Pyrex glass Viton gasketand sanitary clamp.One (1) ½ half- coupling with vacuum gauge.One (1) ½ half- coupling vacuum port with valve.Interior of vacuum/pressure cover polished to a surface finish roughness average (Ra) <0.8 um (~80 grit).Exterior of vacuum/pressure cover polished to a surface finish roughness average (Ra)< 0.8 um (~80 grit).CONTROLS:NEMA 12 Control System suitable for operation at 3 phase 60 Hz 480 volt input. Panel is pre-wired and mounted to mixer and suitable for single point connection to your powersource.One (1) Illuminated Start Momentary Push-button (green) for the agitators.One (1) Stop Momentary Push-buttons (red) for the agitators.One (1) 15 HP Variable Frequency Drive internally mounted.One (1) Speed potentiometer for Variable Speed Control of the agitators.One (1) digital speed readout.Relays for two limit switches wired normally closed.Rotary disconnect.Input Voltage: 480 volt 3 phase 60 Hz.LIST PRICE: F.O.B. BOHEMIA NY: $145000.00OPTION? 50 psig stainless steel type 304 jacket on the vessel sides and bottom.PRICE: $1950.00SHIPMENT: 4 months after receipt of order and down payment.TERMS: 50% down payment with order balance net 30 days after shipment.