Semco GLGD/10

Carter Wilson #2973 - Avail conf. 8/4/14(TEST RUN W/ORDER)12500 - LESS 15% (F.O.B. - LAVAL QUEBEC) Jon the drawings show a design number of 47200049001. They show a telephone number in SaoPaulo Brazil of 55 11 5681 4140 and an E-mail address of semcomaq@semco.com.br 5/28 - per vendor -When the blender is in the discharge position the bottom of the V is toward the floor and the discharge valve is 26 inches from the floor This height can be increased by adding shims or blocks to the support pads.When the blender is in the charge position the two ends of the V are toward the ceiling and the maximum feed point is 80 inches above the floorIf this is not clear call me and I will mark up a drawing with these dimensions5/21/08 - Cust #29707 - Could you send me a couple measurements? (To vendor 5/28) 1. The height of the blender in the loading position. 2. The distance from the floor to the discharge valve in the unloading position. 1/25/06- cust #25386 - The twin-shell at $ 12 500 may be interesting. Is it currently working? One other question I am not very familiar with blender: if the batch I need to mix is about 10 cu. ft. would this blender do the job? Because I imagine that we need to leave some space on top for a good mix? (to vendor 1/25) 1/26/06 - per vendor - Is it currently working. No it is in our warehouse. To our knowledge it works but would have to verify by bringing into our shop and putting power to the unit. I will have to be sure we have a transformer to change our 550 volt to the 440 volt on the motors.